Description
This installation kit includes all the necessary hardware to mount an R200 differential in place and attach it to the driveshaft. Also included are adapters to attach a 5-bolt or 6-bolt differential to stock U-joint axles. Nissan R200 differentials in 3.692:1 and 4.08:1 ratios have 5-bolt axle flanges, 3.538:1 ratio differentials have 6-bolt axle flanges. This is an installation kit only, a used R200 differential and a shortened driveshaft (SKU 107) must be purchased separately.
This kit will NOT fit R200B differentials (SKU 1627,1627, and 1630)
Click here for installation instructions
Click here to go to our R200 Diff Sources and Modifications Info Page for information about finding and modifying your own R200 or R200B differential.
Click here to go to our Viscous Limited Slip info page for information about viscous limited slip differentials (VLSD).
NOTE: Installation of Good Parts rear Nylatron suspension bushing kit is strongly recommended when installing the R200 differential with U-joint type half shafts. The original type rubber bushings allow the trailing arm to shift sideways during hard cornering. This action, combined with binding of the axle splines during acceleration or deceleration has, on a few occasions, disengaged the internal snap ring holding the R200 axle stub into the differential. If the axle stub moves out far enough to disengage its splines, power cannot be transmitted to the wheels. This has not been known to occur on cars using the Nylatron bushings in the trailing arms. Springs are now supplied with the R200 installation kit to install between the axle half-shafts as an extra precaution.
Reviews
There are no reviews yet.