Spring Spacers, Rear, Pair

Description

Use these machined aluminum spacers to adjust the ride height of your TR6. Spacers can be placed on the top or bottom of the spring. Placing spacers below the spring adds slightly to un-sprung weight. Spring packings (purchased separately) should be placed between the spacer and the car frame, not between the spacer and the spring. Packings may need to be trimmed to fit with ½” spacers.

Sizing Guide:

Ride height with Good Parts springs and no spacers is approximately 14-14½ inches from the center of the wheel to the fender edge. Increases in TR6 spring height affect ride height by a factor of roughly 1.75.

½” spacer = ⅞” ride height increase

¾” spacer = 1 ⁵⁄₁₆” ride height increase

1” spacer = 1 ¾” ride height increase

* Ride height measurements are estimates, individual results may vary from car to car.